Concrete Products is the leading source for Concrete Plants, Concrete Mixers, Precast, and Ready Mix news.
 
 

 

Total: 38 results found.

Search for:
Search Only:

Page 1 of 2

1. Chemical-resistant precast liner
(Innovations)
... A flexible PVC alloy membrane is prefabricated to slip over formwork for ease of installation. A polypropylene fiber backing provides near complete mechanical adhesion of the liner to the precast concrete ...
Created on 29 September 2019
2. A-Lok, Seaman parlay corrosion resistance technology for precast
(Concrete Currents)
... a key player in underground precast connectors, gaskets and accessories. A prefabricated PVC alloy with polypropylene fiber backing, the Quikliner is based on XR-5 technology, which has been deployed for ...
Created on 24 September 2019
3. Law of attraction: Magnetic formwork systems increase efficiency
(Innovations Reports)
... to each other or cut, depending on the required dimensions. Spartan sideforms feature PVC caps that can be interchanged with other types of caps to incrementally increase sideform height by either ½ ...
Created on 16 May 2019
4. TRB 2019: Reduce portland cement content by optimizing gradation
(TECHNICAL TALK)
... for installing ECON HPS using two-lift concrete paving: upper left, prepare base and place dowel baskets and PVC conduits; upper right, place portland cement concrete layer, or bottom layer, on the prepared ...
Created on 30 April 2019
5. PVC paver edge restraints
(Innovations)
Product engineers present Pave Edge as proven restraints that withstand greater loads, exhibit lower deformation and require fewer spikes than typical systems. PVC plastic construction affords the restraints ...
Created on 27 July 2018
6. Buried Structures lab study confirms escalating water main break rates
(Government Affairs)
...  Cast iron (CI) pipes represent the largest pipe material inventory and 82 percent of all CI pipes are over 50 years old; Construction-related failures were equivalent for both PVC and ductile iron ...
Created on 26 April 2018
7. Mixer, pump truck washout containers
(Innovations)
... sizes matching the All-Weather models; and, PVC Washout, geared to large mixer truck or pump washout volume requirements, fabricated from 10-oz. material and available in 6- x 8-ft. and 8- x 10-ft. sizes. ...
Created on 29 November 2017
8. Washout vessel
(Innovations)
Built of durable PVC, the WashoutPRO offers 150 gallons of mixer truck or pump material or water discharge capacity.   The 63- x 12-in. vessel folds to 14- x 14- x 12-in. and is available with a ...
Created on 29 November 2017
9. VersaFlex coatings ensure an urban oasis remains watertight
(Innovations Reports)
... movement and still not leak. Pierce says that some of the Fountain Place’s pools above the parking garage had been remediated with a PVC roofing membrane with heat welded seams, but still had leakage ...
Created on 02 November 2017
10. Besser, ACPA Foundation present first Pipe Scholarship
(Briefs)
... South Carolina. He spent the first 21 years of his professional career in the natural gas industry, followed by seven years in PVC sheet pile and HDPE drainage products businesses prior to joining ACPA ...
Created on 25 May 2017
11. State Engineer Tripp takes helm at American Concrete Pipe Association
(Concrete Currents)
... in Civil Engineering from Clemson University, South Carolina. He spent the first 21 years of his professional career in the natural gas industry, followed by seven years in PVC sheet pile and HDPE drainage ...
Created on 28 March 2017
12. Pre-fabricated liners offer precasters speedy alternative to surface-applied coatings
(Innovations Reports)
Precast producers have a new method of protecting concrete water and wastewater structure interior surfaces. Rigid HDPE and PVC liner systems and post production, surface-applied coatings considered standard ...
Created on 22 February 2017
13. Licensed system brings precast efficiency to light pole bases, foundations
(Innovations)
... and #3 round tie steel bars; and, fabricated with four galvanized anchor rods plus four PVC electrical conduits for light pole mounting and wiring. The Pole Base is simple to design and install, and ...
Created on 11 August 2016
14. Precast barriers, double tee girders get look at TRB 2016
(Features)
... 18 stem, and a 3/4-in.-diameter tie bolt to restrain widening of the gap between the stems. The cylinder ends were chamfered to allow for a snug fit between the stems. A 1-in.-diameter PVC sleeve at the ...
Created on 08 March 2016
15. Construction life cycle assessment pioneer retools Buildings, Pavement programs
(News Scope)
... PVC roofing membrane, aluminum and metal cladding product updates. PAVEMENT LCA This is the assembly form where you input your roadway design in Pavement LCA. Pavement LCA Version ...
Created on 24 September 2015
16. Athena Institute collaborative updates Impact Estimator for Buildings
(Concrete Currents)
... materials, Impact Estimator for Buildings Version 5.1 contains PVC roofing membrane, aluminium and metal cladding product updates. The software is available as a free download. Related article Construction ...
Created on 03 August 2015
17. Galvanized pipe, safety-wise proximity switch signal Skako Atlantis evolution
(Innovations)
... access; galvanized steel in lieu of PVC pipe for batch water; and, coded safety proximity sensor on the mixer discharge door. Two-part, coded magnetic sensors (shown in red)—one mounted on the mixer frame, ...
Created on 11 May 2015
18. Market conditions favor Hanson products business public offering
(Editorial)
... statement. The IPO would follow a similar offering earlier this year for PVC pipe leader, Advanced Drainage Systems—a NYSE-listed counterpart of Hanson Building Products’ largest business, Hanson Pipe ...
Created on 25 October 2014
19. Sidley streamlines sand storage
(Final Form)
... 4,000 psi concrete and reinforced with conventional bar or wire mesh per engineering conditions. Members can be made with weld plates, PVC conduit or other connection means if a project requires.   ...
Created on 01 April 2014
20. VEGETABLE OIL-BASED RELEASE AGENT
(Innovations)
... and cuts labor costs of form cleaning time up to 70 percent. Regular use keeps forms clean when used on non-pourous forms and form liners made of plastic (ABS and PVC), elastomeric (urethane and silicone ...
Created on 04 December 2013

Resource Center